F22 Flying Glider Powered by an Elastic Band
F22 Flying Glider Powered by an Elastic Band
Published 2015-09-07T10:57:06+00:00
Inspired by the amazing Super Stratos Glider comes a colection of 3D printable plane models of real aircraft that actually fly!
Here's the F22 fighter jet, used by the US Air Force. Capable of cruising faster than the speed of sound and with the processing power of 2 Cray supercomputers in the cockpit this plane is the most advanced fighter jet in the world. This model is true to the F22's form as much as was possible whilst still getting a good flight (the supercomputers were left out!). Quick, cheap and easy to print (support free), these planes provide hours of fun and all you need is an elastic band!
If you have a heated/glass print bed then it can save you a lot of time and effort if you print the glider without a raft. Your print layers need to be set to either 0.2mm or 0.1mm (the wings are 0.4mm thick and the wing detail an extra 0.2mm). Your initial print layer cannot exceed 0.2mm. Ideally align your first print layer running parallel to the cockpit and then vary your print layers by 90 degrees (not 45 degrees) to prevent warping of the wing. It's not the end of the world if you don't do this but it is recommended. The dihedral wing joint (the two grooves running down the cockpit) must be clamped and glued to the central shaft in order to pull the wings up into a shallow, symmetrical 'V' - highly important for stable flight. Assemble using a good model glue. I've found the best technique for launching is: Attach an elastic band, you can use trial and error to find your preferred length and strength, to the 'trigger'. Hold the plane by the rear, put your first and second fingers on the top side and your thumb on the bottom. Pull back and increase the tension in the elastic band making sure it isn't twisted. Aim the plane at a slight upward angle and fire! From experience, if flying your plane in a field with long grass make sure you keep an eye on where it lands!
发表的日期 | 07/09/2015 |
让时间去下载 | 300 - 分钟 |
尺寸大小 | 233mm X 150mm X 15mm |
复杂程度 | 中级 |
支持自定义 | YES |
11cm length Printed using Woodfill PLA 200°C Nozzle and a 50°C bed