levered-power wheelchair (inspired on Hand Drive)
levered-power wheelchair (inspired on Hand Drive)
3D
Published 2018-09-03T17:12:22+00:00
This object can be attached to a wheelchair to power it by rowing motion. It was inspired on the open source design publised on https://hackaday.io/project/7221-hand-drive .
It's very similar, but my design doesn't have the gears parts (I try to made it simpler)
The design is only for forward, but it has the gear tooth for backward motion (a system with
cables must be built, like the original Hand Drive)
This object was made for the "Mutual de Seguridad C.Ch.C" from Chile. In a project of the Direction of innovation and development, and the Neuro rehabilitation institute.
Post-printing:
Materials: 3d printed parts, 4 screws, 3 washers, 1 traction spring, 1 bearing.
Assemble the spring to the rachet.
Assemble the rachet to the “Bar support” part. Put a washer in between.
Put the bearing on the “Anular” part.
Assemble the “Bar support” with the “Anular” part. Put 2 washers in between,
and two nuts at the end of the screw (it prevent them from getting out with the spin)
| 发表的日期 | 03/09/2018 |