Prosthetic/Robotic Hand Printable As An Assembled Unit Without Supports
- 教育>
- 生物 |
- 教育>
- 生物>
- 骨架 |
- 入门级>
- Prosthetic & Orthotic>
- Prosthetic |
- 教育>
- University>
- Life Sciences>
- Biomedical Sciences
Prosthetic/Robotic Hand Printable As An Assembled Unit Without Supports
3D
Published 2017-04-18T15:31:59+00:00
You might have heard about the 3D-printed prosthetic hands created by Richard Van As and Ivan Owen for about 100 children thus far. That's a great thing they've been doing. There's also a "Snap-Together Robohand" version, thing 92937, which is intended to be easier to build. I'm sure it is... but it still takes half a day to print the parts and assemble them. Unfortunately, I had less than 3 hours total on Saturday, September 28, 2013, to give an overview of making technologies and have YMCA Black Achievers students actually build something.
So, I designed a new prosthetic/robotic hand for which all the printed parts print assembled without supports in less than an hour. You still have to thread some fishing line and rubber bands through it, but from print start to working hand is easily done in less than 90 minutes using a total of about $1 worth of materials!
Printed in PLA at 195C, 0.25mm, 25% fill. Sliced using cura.
An Instructables gives the details:
http://www.instructables.com/id/ProstheticRobotic-Hand-Printable-As-An-Assembled-U/
For now, I just have the STL file posted. However, this was built with the same not-yet-released hinge library I tested by making Thing 120179, and I plan to post the openscad source for this too.
| 发表的日期 | 18/04/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |
