Rear Tail light with light guide
Rear Tail light with light guide
3D
Published 2015-09-22T16:01:16+00:00
this entry is for rear light challenge.
a stylish rear lamp using 3D printing technology will make advantage in it.
instruction for assembly
Rear light having below parts
Housing- 01 qty(pc+abs material)
Lens - 01 qty ( pc clear material)
Light guide Lower - 01 qty ( pc red material)
Light guide upperc- 01 qty ( pc red material)
Reflector - 01 qty (hard plastic with metalic finish material)
Screw - 04 qty (hard plastic)
Back cover - 01 qty(soft plastic)
first assemble reflector into housing then attache light guide into reflecotr ,second aatche LED assembly into reflecor with screw.
then cover housing with back cover from back side.
assembly led light into housing packaging area.
finaly assemble Lens into housing and its all done your rear light guide tail light is ready.
cheers
Print at 0.2mm layer height and 10% infill.
| 发表的日期 | 22/09/2015 |
| 让时间去下载 | 1140 - 1150 分钟 |
| 材料数量 | 136 g |
| 尺寸大小 | Multiple parts |
| 复杂程度 | 中级 |