TOONED BIRDHOUSE V2.0
$4.95 TOONED BIRDHOUSE V2.0
3D
Published 2022-04-11T15:01:04+00:00
For full access to all my models + exclusive models and for commercial license:
https://www.patreon.com/PA1_MAKER
FEATURES:
-100% support free
-All parts are already placed in the right orientation
-Large bottom door for cleaning between seasons
-2 diameters of entrance included: 28.5mm, 32mm (1.125in, 1.25in)
-Detailed exploded view to help you with the assembly
-Big parts can be done with a layer height of 0.3 with no problem to speed up printing time.
-Sturdy and strong design, with thick walls that won't deform overtime.
Be sure to have your bridge settings at "ON".
For the small parts, use 4 walls. This will make a stronger piece.
Watch for over extrusion. If you're having some fitting problems, simply sand gently the parts to help them fit together. But with a good calibration, everything should be fitting together very well.
FOR THE ROOF NUMBER 02: Two version are included. One vertical, one laying flat on bed. The one laying flat is the easiest one. The vertical one gives better printing definition and results. If you choose the vertical one, i suggest that you use paint-on-supports to add a line of supports at the back of the roof. Just to prevent vibrations and troubles...
FOR THE DOOR AND THE FRONT WALL: Use a color change to have the same result in the pictures. Few bricks on the wall are higher than the others and the door trim is also higher. So you can easily make a color change on the last layers of those parts.
All the rest is multi-part.
This one, due to its shape, is made to be mounted on its support, on a fence, a wall or a post. If you wanna hang it instead, try to figure out where the center of gravity is before drilling holes for the ropes. Center of gravity will change from one printing setup to another, so i didnt include pre-drilled parts like the other one.
If you choose to hang it, don't forget to seal the holes to prevent any water getting in.
If you have any problems, just send me a message.
Have fun!!!
| Date published | 11/04/2022 |
| Precio | $4.95 |
| Sin apoyo | YES |
