mrx3's Print of MI-24 Valk-D
Destacado
266
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de MI-24 Valk-D
Published 2024-04-23T14:16:40+00:00
1
0
Impreso con: Phrozen Sonic Mighty 8K
Material: Others
Descripción
I think this is one of the greatest proxies ever created.
Might have to make an extra support at the back end though. I have to store upside down. But it is still lightweight as long as you use the hollowed out supported versions which print fairly well. I did have the temperature dipped down one night and mess up the left wing because I accidentally unplugged my heater for the printing room and dipped down to about 70°F. I normally print at 80°F and everything comes out perfect. After some priming and painting, the wing came out pretty decent in the end. It took a total of 48 hours and two printers, one a mini and one mighty.