Industrial Bevel Gearbox / Gear Reducer (Cutaway version)
Industrial Bevel Gearbox / Gear Reducer (Cutaway version)
Published 2018-08-10T14:36:13+00:00
PART OF MY INDUSTRIAL GEARBOX COLLECTION
This is a fully 3D printable version of an industrial bevel gearbox / gear reducer. This cutaway version can be used for training purposes, and has a gear ratio of 1:1 (no reduction)
Bevel gears
A bevel gearbox is mostly used to redirect the motion of a shaft. You can find these gearboxes in most outboard motors, helicopters and in the differential of most cars.
No additional hardware needed!
UPDATE 7-16-2018
I`ve added a cap that can make the gearbox non-cutaway, see the green parts in the fourth picture. When you want the gearbox to be non-cutaway, you have to print the 2 files named with NON-CUTAWAY.
Print settings
Axle
Support: No
Infill: 40 – 60 %
Layer height: 0.1 – 0.3 mm
Bevel Gear 1
Support: No
Infill: 40 – 60 %
Layer height: 0.1 – 0.3 mm
Bevel Gear 2
Support: No
Infill: 40 – 60 %
Layer height: 0.1 – 0.3 mm
Handle
Support: No
Infill: 40 – 60 %
Layer height: 0.1 – 0.3 mm
Housing top
Support: No
Infill: 20 – 40 %
Layer height: 0.1 – 0.3 mm
Housing
Support: No
Infill: 20 – 40 %
Layer height: 0.1 – 0.3 mm
Stop
Support: No
Infill: 20 – 40 %
Layer height: 0.1 – 0.3 mm
NON-CUTAWAY cap
Support: No
Infill: 20 – 40 %
Layer height: 0.1 – 0.3 mm
NON-CUTAWAY house
Support: No
Infill: 20 – 40 %
Layer height: 0.1 – 0.3 mm
The clearances of this model are between 0.2 - 0.4 mm (0.008 – 0.016 inch). You might need to drill out the holes for the axles (9 mm), or sand some of the parts to make them fit.
Date de publication | 10/08/2018 |
Technologie | FDM |
Complexité | Easy |
Sans support | YES |
Absolutely awesome design, well done! Made from Woodfill PLA by Colorfabb and Wizards Voodoo PLA by Fillamentum. 0.6mm nozzle, 0.2mm layer height, 20% infill, @ 50mm/sec print speed. Print time 4 + 6 hours.