BATTLETECH ASF KS Shilone Landing Gear
2,943
views
304
downloads
13
collections
0 comments
Loading comments...
BATTLETECH ASF KS Shilone Landing Gear
3D
Published 2021-12-26T09:33:57+00:00
53
0
Add to Collection
Description
This is adaptor that can fit into the ASF Shilone fighter so that you can place it on a flat surface and it would keep the wings off the "ground".
I personally have been using it without being glued in, and so far the connector has been ok. But do be careful with the part so that it doesn't break while attached.
License
Printing Details
Test prints were on a Mars 2 Pro; at 0.025mm layer height, time was about an hour. Curing time was in a Mercury Plus, at 1 min.
There WILL be resin bloom when curing etc. so best to keep the times a bit conservative. These parts need to fit into the existing peg and hole of the mini, so you want to minimize the bloom.
Technical Information
Date published | 26/12/2021 |
More Information
Object Parts