Pod Walker
Pod Walker
Published 2018-06-19T15:34:09+00:00
Hi!
This is another robot/mecha/walker ready to print in parts then assembled.
Choose your favourite colour combo and print!!
Using the same pilot that i made for 'Tow Walker'
Tolerances set around 0.2 mms so you shouldn't need sanding. If some parts comes loose when assembling my best tip is using a bit of tape (see below) to made a strong fit.
I could print at 50% (in 5 hours) and it works!!
Include a full-plate.stl with all the parts ready to print-in-place (fits in a 18x18 cms plate). Also there's 2 files 'full-color1.stl and full-color2.stl with the parts i've print in diferent colors
NO SUPPORTS NEEDED!!! :D
Hope you like it.
Have fun!!
Nothing special, i printed using 3 perimeters, 3 bottoms and 4 tops. Yo don't need supports and can even print hollow but i used a 20% infill just to be 100% sure.
Date published | 19/06/2018 |
Technology | FDM |
Support Free | YES |