roybijster's Print of Necromanteion of Acheron
648
views
0 comments
Loading comments...
Community Print 3D Print of Necromanteion of Acheron
Published 2021-12-19T18:53:56+00:00
2
0
Printed on: Prusa i3 MK3
Material: PLA
Description
Just finished printing the Portal. Quite a few seams to fill, but that looks pretty doable. Printed in PLA on FDM. 0.1 mm layer height. Took 44 hours. The suspended pieces of brick on the top right of the model was pretty hard to locate. Took me a while to figure there were small notches to attach that part to.
For anyone else figuring out how to put this together. The rest is indeed pretty straightforward as crippledgodfoundry said above.